How to create the Reference Data of SIGNS for Controlled Areas Panel in DA

This article will explain how to record SIGNAL information for use in the Controlled Areas Panel in the DA.

This is the initial configuration for later configuring the Controlled Areas panel.

This panel is very important for mining companies because it allows them to monitor and follow up on extremely dangerous zones or areas where personnel must enter. Therefore, this panel helps the occupational safety department by controlling the time during which people will be working in these high-risk areas.

To configure this panel, you must first record the SIGNALS and TYPES of SIGNALS that may exist in the mining operation. An example might be that a rockfall could occur. It should be created in the SIGN TYPE: "Rockfall." In the SIGN table, "Rockfall No. 1" could be created. If there are two locations with this condition, only one can be used at a time for one location.

1. Create the Sign Types.
   • Open the DOME
   • Select "Reference Data"
   • Go to the path: "Groups->Configuration Items->Signs->SignType"

     

• Create a Sign Type: "Checkout"->"New"->Put the information->"Ok"->"Checkin"

2. Create the Signs

• Open the DOME
• Select "Reference Data"
• Go to the path: "Groups->Configuration Items->Signs->Sign"

  

• Create a Sign: "Checkout"->"New"->Put the information->"Ok"->"Checkin":

  

  3. Publish the information

With these steps you can initial configure the SIGN information.

Want to learn more?

Online Help Manuals - Click here for the latest version

Learning Management System - Click here to login or here to request access